词语屋>英语词典>nozzle翻译和用法

nozzle

英 [ˈnɒzl]

美 [ˈnɑːzl]

n.  管口; 喷嘴

复数:nozzles 

化学

Collins.1 / BNC.16192 / COCA.13369

牛津词典

    noun

    • 管口;喷嘴
      a narrow piece that is attached to the end of a pipe or tube to direct the stream of liquid, air or gas passing through

      柯林斯词典

      • N-COUNT 管嘴;喷嘴
        Thenozzleof a hose or pipe is a narrow piece fitted to the end to control the flow of liquid or gas.
        1. If he put his finger over the nozzle he could produce a forceful spray.
          如果他把手指按在喷嘴上,就可以产生强力的喷射。

      英英释义

      noun

      双语例句

      • Effect of Submerged Entry Nozzle ( SEN) argon blowing on slab quality has been investigated stimulatingly and experimentally.
        本文以连铸板坯机为研究对象,研究探讨了浸入式水口吹氩工艺对铸坯质量的影响。
      • In diesel premixed combustion mode, the effects of nozzle cone angle on emissions were studied.
        进行了在柴油可控预混压燃燃烧模式下,油嘴喷射锥角对燃烧与排放的影响研究。
      • Combination simulation method with SEM technology, erosion mechanisms of BAT nozzle is researched.
        结合仿真技术和扫描电镜技术,分析了BAT喷嘴的冲蚀机理。
      • The experimental investigation of the operational characteristics of fuel nozzle for a heavy gas turbine was performed.
        对某重型燃气轮机燃料喷嘴的工作特性进行了试验研究。
      • Please specify both required suction vacuum and full load capacity or required bypass nozzle diameter.
        请指定所需的真空吸力和满负荷的能力,或绕开喷嘴直径。
      • Mechanism of axisymmetric vectoring exhaust nozzle ( AVEN) is analyzed in the view of elastodynamic capabilities.
        对轴对称矢量喷管机构进行了弹性动力学分析。
      • The article explores swirling abrasive water jet from angles of nozzle wear mechanism and drilling.
        本论文从喷嘴磨损机理和钻孔效果两大部分对旋转磨料射流进行了探索性的研究。
      • The truncated nozzle is found to have a higher thrust.
        截断的喷管具有较大的推力。
      • The feasibility of counterflow scheme is validated by research on the internal aerodynamic characteristics of nozzle using numerical simulation.
        利用数值模拟的方法,通过对逆流方案中喷管气动性能的研究验证了逆流推力矢量方案的可行性。
      • Each tube is in front of the collector nozzle only long enough to discharge the processed air.
        每一个管子在集气管前停留的时间,只要足以放出处理过的空气就可以了。