swabbing

英 [ˈswɒbɪŋ]

美 [ˈswɑːbɪŋ]

v.  用拭子擦拭; 擦洗，擦拭(地板等)
swab的现在分词

化学经济

柯林斯词典

• (医用)拭子，棉签，药签
  Aswabis a small piece of cotton wool used by a doctor or nurse for cleaning a wound or putting a substance on it.
• VERB (用拖把、抹布等)擦洗，擦拭
  If youswabsomething, you clean it using a wet cloth or a tool called a mop.
  1. I noticed a lone man in the cafeteria swabbing the floor as I passed.
     我路过时注意到一个男子独自在自助餐厅里拖地。

英英释义

noun

• cleaning with a mop
  1. he gave it a good mopping
  Synonym:mopping

双语例句

• Install the drill pipe wipers when the driller is satisfied with the condition of the hole and that swabbing does not take place or when the bit is inside the intermediate casing.
  当司钻认为井下已经正常不会产生抽吸时，或钻头已经进入技术套管内，才能安装钻杆刮泥器。
• Research and application of the combined operation technology of straddle test, perforation and swabbing
  跨隔射孔测试抽汲三联作技术研究与应用
• The optimal design methods of submergence pump depth and other swabbing parameters were presented. The application results show that the system efficiency and the economic benefit are enhanced by the submergence depth optimal design.
  应用结果表明，以优化设计方法来确定泵的沉没度，可明显降低能耗，提高系统效率和经济效益，为油田生产提供设计依据。
• When using this method every parameter is comprehensively evaluated according to the integrated decision theory of fuzzy mathematics. It comprehensively reflects the effect of each factor on the optimizing design of swabbing parameters, and then provides the optimizing designing project for swabbing parameters.
  该方法利用模糊数学综合决策理论对各个参数进行综合评价，全面地反映出了各种因素对抽汲参数优化设计的影响程度，从而给出抽汲参数的最佳设计方案。
• Taking the non-Newtonian behavior of the produced fluids into account we put forward the optimizing design method of swabbing parameters for polymer flooding.
  考虑到采出液的非牛顿特性，提出了聚合物驱抽油井抽汲参数优化设计方法。
• Slug flow appears very often in swabbing well and usually results in complexity of bottom hole pressure change, and swabbing recovery may make bottom hole pressure more unforeseeable.
  抽汲井极容易出现段塞流而导致井底压力变化非常复杂，采用的抽汲生产将进一步加剧井底压力的不可预见性。
• Application of Combined Technique of Fracturing and Unloading by Swabbing in Shengli Oilfield
  压裂与抽汲泵返排联作工艺在胜利油田的应用
• In order to decrease swabbing leakage and save energy sources in the swabbing operation, assay the problem of the tube type swab, improvement of the structure and design of the slipper type swab are described in this paper.
  为了降低在捞油作业中油的漏失率，节约能源，分析了筒式捞油抽子的问题，改进其结构，设计了滑块式捞油抽子。
• Combined the layer inflow performance and coordination principles of inflow and outflow at the pump point, pump-in pressure have been ascertained by multiphase pipe flow, the best depth of plunger for the different swabbing parameter have been ascertained.
  结合地层流入动态和油井供产协调原理，利用多相管流计算泵吸入口压力，提出了不同生产参数下的最佳泵挂深度确定方法。
• Optimization design method for pumping unit, rod, pump& swabbing parameters of horizontal well
  水平井的机、杆、泵及抽汲参数优化设计方法